APC Precision Wax Polish is a water-based acrylic & wax co-polymer which forms a tough abrasion resistant clear non-yellowing top coat polish to protect existing sealers and finishes. This co-polymer offers excellent gloss and can be stripped with conventional wax polish removers. Its toughness protects the existing finish and acts as a sacrificial coating for the hard sealed substrate. APC Precision Wax Polish resists scuffs and mars while enhancing the gloss of the finish below. APC Precision Wax Polish also increases slip resistance. It is designed to be applied on top of existing acrylic, polyurethane, and epoxy sealers. It is used on newly sealed floors and to restore shine on previously sealed concrete floors.
- APC Precision Wax polishes interior concrete floors.
- It enhances decorative systems including stained concrete floors on both newly sealed floors and to regain the luster to worn areas of previously sealed and polished floors.
- APC Precision Wax Polish may be used in restaurants, stores, malls, office buildings, healthcare centers, hotels, motels, etc.
Floor should clean and sealed
Apply with lambs wool, sponge mop, or micro fiber applicator. 2 or 3 initial coats may be preferred. Allow 30 -60 minutes between coats to dry. Buffing with high speed buffing machine will maximize luster of Super Sealer Wax. Allow 4 hours to cure and dry before foot traffic resumes. Re-apply as needed.
Maintenance cleaning of the polished surface should be accomplished using ONLY water or Pledge Multi-surface cleaner and a soft mop. DO NOT USE aggressive cleaning agents, such as citrus-based, ammonia, or 409/Simple Green cleaners. Using an abrasive cleaning tool will scratch and dull the polished surface, requiring re-application of Super Wax to restore the shine.
1000 ft2 per gallon per coat. 2-3 coats may be preferred.
Clean up with water immediately after use.
Solids: 30% Density: 8.5 lbs/gallon
VOC: 0.56lbs/gallon (67 g/l) pH: 8.0-9.0
Flash point: Non-combustible Freeze/Thaw: stable